Quote:
| Originally Posted by aquaholic As far as I remember, the new MDE isolation centre and pillar valve connections are standard DIN (female at the Pillar valve end, male at the centre end) - so a female to male decanting whip should do the trick nicely  .
Where are you going to get your stainless frame made? Would also be interested in one of those for the KISS if the centre stay could be adapted to bolt into the KISS CL case... |
Mine are the new kind, and I am 90% certain they are DIN, however, I am also 90% certain that one of them has a left hand thread. It is how you adjust twinsets, to make them parrallel, by turning the centre isolator, therefore one HAS to be L/H. This however, would not be a problem, as I would just mount the isolator on the L/H thread, and have the flexible on the R/H, and a M-F decanting whip would be perfect, but, probably far too long.
However,
sub-aqua do all the bits and bobs necessary.
Female Din ( 232 bar ) To 1/4 Bsp Female - Goes on the centre piece.
Adaptor Brass 1/4m X 1/4m Bsp - To fit the above adaptor to the flexible hose
02 Hose/Polymid/Nylon Core/1/4 X 50 Cm - Flexible hose with 1/4" bsp femal swivels (may use the stainless one)
Din Adaptor To 1/4 Bsp Ml (232 Bar) - Screws into the pillar valve
Hopefully, once full assembled, the whole jobby shouldn't be too bulky, whilst offering even more backup over independents.
As for the stainless frame, I am in the middle of the drawing, and will just approach a couple of marine stainless fabricators.