Quote:
| Originally Posted by SteveJ Thanks.
Argon it is then. Where do you get the fills? LDS? Welders??
Also Guys, wot did you run in your stages? I'm assuming bottom mix in Left side and either a 50% or 100% O2 in Right.
Steve |
you can just use air in the argon tin to save your money and it's a lot easier to get. plus unless you fill and empty your suit to remove most of the air and replace it with the argon gas, i don't think you will notice any difference in it's thermal properties.
as for bail out gas i use 10/52 in the bottom mix (left side) and 50% (right side) if you use 50% in your rich mix you can get on it a lot sooner than 100%
hope this helps
