Inspiration stainless backplates for sale

[johnmaneely]

Hi,
I've made some backplates for the Inspo, they have a cut out in them so they miss the moulded clearance bulge for the manifold on the back of the case. This allows the backplate to sit flat against the case all the way up. Normal plates sit a bit wobbly and proud at the top.

The backplate also has larger width slots for the lower waist band webbing, allowing adjustment of the shoulder straps of the harness whilst your wearing the unit. Something I find useful with a one piece harness, oc or cc.

They will of course fit anything with 11" stud centres, all your usual twins and breathers. They are 3mm 316 stainless, haven't weighed one yet, think there 2kg, though I could a little out.

I made these for the older type Inspo case but think the later abs case is the same(with the bulge and in the same position)can anyone confirm this? thanks.

I wanted one so I made it, but thought I'd make a small batch to try and sell 'em as it wasn't to much extra hassle. If you want one there £50 plus the postage, or you can pick it up from near brighton.

Any questions post them up here, email or pm, cheers
John
johnmaneely@hotmail.com

[johnmaneely]

http://i81.photobucket.com/albums/j2...y/P1030015.jpg

A bigger picture can be found here.