YD Scuba Diving Forums banner

Draeger P port Question

2K views 3 replies 2 participants last post by  narked at 90 
#1 ·
Hopefully someone on here can help!
Does anyone know what the spec's for the thread on a Draeger P port are?
Where I want to use one I'm going to need to cut a thread into the botom of a scrubber!

Cheers
Simon A
 
#2 ·
Simon A said:
Hopefully someone on here can help!
Does anyone know what the spec's for the thread on a Draeger P port are?
Where I want to use one I'm going to need to cut a thread into the botom of a scrubber!

Cheers
Simon A
hi simon, some one asked this a wile back some where on a site
i'll have a look but i think it was m38 by 1mm..
but let me check
johnroutley
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top