YD Scuba Diving Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter · #1 ·
I have a ATX200 bought in 2004, that is where the first stage is mat.

My Manual states:

PRESETTING THE SPRING ADJUSTER
11
Push the spring adjuster (16) into the adjustment knob (19). Using a 5mm hex key, tighten the spring adjuster until flush with the top of the adjustment knob. Then turn the spring adjuster
CW six-360 degree turns to preset.

Here is the confusion; 'tighten the spring adjuster until flush with the top of the adjustment knob'. It is already flush if I put it in. So if I ignore this and start my six turns it works. After doing the six turns it leaves it one-360 degree turn short of the max it can turn. In other words it is the same as one turn ACW if i turn it first till it turns no more.

Do you guys think I understood this correct? Or does anybody have an other experience?
 
1 - 1 of 1 Posts
Top