YD Scuba Diving Forums banner

1 - 4 of 4 Posts

·
Premium Member
Joined
·
5,739 Posts
Discussion Starter · #1 ·
Imported post

What I need to know is how easy will it be to convert my existing kit over to DIN.

1. Apeks TX100 1st stage - I believe there is a conversion kit available. Anyone any idea about this?

2. Apeks TX50 - On a different (DS4) 1st stage - will the same conversion kit work dor this?

3. I think most modern cylinder valves can be easily adapted to accept DIN regs (by unscrewing the middle out) - is this correct?

4. How much will this cost and are the fittings then interchangeable (ie when I go abroad, can I change the regs back to yoke clamps?)

Regards
 

·
Gone...and probably best forgotten
Joined
·
1,403 Posts
Imported post

You mean to tell me we havent covered this ground before?  Divers Warehouse converted my 1st stage, about £20 I think.  As for going back to A-clamp, a yoke fitting costs about the same.
 

·
Gone...and probably best forgotten
Joined
·
1,403 Posts
Imported post

yep
 
1 - 4 of 4 Posts
Top