YD Scuba Diving Forums banner

1 - 12 of 12 Posts

·
Driving my truck with my high-heels on...
Joined
·
5,509 Posts
Discussion Starter · #1 ·
any body know the ip for the apex & posieden 1st stages ?
 

·
Radioactive Diver
Joined
·
250 Posts
any body know the ip for the apex & posieden 1st stages ?
Apeks 9.5 bar
Posiedon 12-13 bar? (I think, it is a lot higher than the Apeks) Which is why a Posiedon reg wont run off an Apeks reg (it free flows, as not enough pressure to operate the servo)

Hope that helps!
 

·
Driving my truck with my high-heels on...
Joined
·
5,509 Posts
Discussion Starter · #4 ·
Hmmm the apex sits at 10 bar according to my ip gauge & the posiedens only sit at 9 bar ,also the posiedens will drop to 7 bar while breathing & are sluggish in recovering to 9 bar but the apex only drops to 9 1/2 bar & recover instantly .:confused:
 

·
Just A Diver - Nothing Special
Joined
·
478 Posts
manual says jetstream 2960 145psi / 10 bar
3960 145psi / 10 bar

cyklon / thor are higher
 

·
Driving my truck with my high-heels on...
Joined
·
5,509 Posts
Discussion Starter · #7 ·
I think your Apeks are fine but the Poseidons need sorting.
the apex are borrowed & my jetstreams have only just been serviced :frown:

edit: but I do tend to agree
 

·
Driving my truck with my high-heels on...
Joined
·
5,509 Posts
Discussion Starter · #10 ·
Well I have the club compressor & the O2 & some He .The club has no equipment other than the air filling bits so I suppose thats me then Dave :angel:
 

·
Radioactive Diver
Joined
·
250 Posts
Just checked my Posiedon manual, IP should be 11.5-12.5 bar, for Cyklon. But depends on model. 9-10 bar is usal for JETSTREAMS
 

·
Driving my truck with my high-heels on...
Joined
·
5,509 Posts
Discussion Starter · #12 ·
Spoke to the actuall technician who serviced mine & he said he had set the ip at the lower end ,he agrees that they should not be sluggish on recovery & told me to drop in with them & they will check & rectify so fair enough
 
1 - 12 of 12 Posts
Top