YD Scuba Diving Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
5,602 Posts
I'm pretty sure that when you tighten in nut 1 to your cylinder valve...you should be able to wind the whole manifold in and out to give you the required adjustment.

Fit the bands first...measure your valve centers or the gap between them. Then remove your bands and fit your manifold...tighten and adjust and then refit your bands.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top