YD Scuba Diving Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
599 Posts
Discussion Starter #1
Imported post

does any one know if I could use a first stage a seac on a din fitting and use a dacor second stage on it. I use it on my pony so its just a back up, the dacor reg was my primary reg but it has been replaced but the first stage was a A clamp fitting hence the need to use the seac din
 

·
Registered
Joined
·
1,121 Posts
Imported post

Erm, you could (possibly) get the a-clamp converted to DIN or simply put a slug into the DIN PV? Mixing and matching should be okay as long as there is nothing fancy (irregular port sizes (Apeks), DFC (Mares) or servo-assist (pozzie) ) to worry about, just check the 1st stage is set to the correct IP (Interstage Pressure not Internet Protocol)
 

·
Registered
Joined
·
2,773 Posts
Imported post

Jepp Nigel
you can mix them two because they both work with an IP of around 10 bar.
 
1 - 3 of 3 Posts
Top